Dr. Pen cartridges compatible with the A6S Ultima (1 Pack of 10)

• The needles are made of high-quality stainless steel
• The 11 pin suits anti-ageing and skin texture applications best
• Ensure to use a new one each time, don't reuse

The 11-pin Microneedle Cartridges are ideal for targeted facial microneedling treatments where more focused stimulation is required. They are commonly used to address deeper acne scarring, stubborn wrinkles and areas requiring more intensive collagen induction. They provide a more aggressive treatment compared to higher-pin cartridges and are best used on specific facial areas rather than the entire face.

Here is the cartridge selection guide for more information.

How does Dr Pen work?

The needles create tiny micro-cavities in the skin's surface. This stimulates the regenerative processes that naturally take place in the skin everyday. This, in turn, stimulates an increased production of collagen and elastin causing the skin to become firmer, for scars to gradually reduce and for wrinkles to smooth out.  

Advantages of using Dr Pen

• Short treatment time
• The precision of the procedure
• Solid performance
• The possibility of working in wired and wireless mode
• Automatic injection depth control
• Less pain and greater comfort for the patient
• Shorter convalescence time

Important: Microneedling cartridges must be sterilised before each use to ensure the treatment is safe and hygienic. It is essential to follow these steps carefully to ensure that the microneedling cartridges are properly sterilised. Here are the steps to sterilise microneedling cartridges:

1. First, ensure that you have all the necessary equipment for sterilisation; gloves, isopropyl alcohol solution (70% or above) and a clean container to hold the solution.
2. Put on your gloves to avoid contaminating the cartridges during the sterilisation process.
3. Check on your cartridge; ensure the needles are in perfect condition (i.e. not bending) and remove any debris.
4. Pour enough alcohol solution into the container and dip the cartridge needle into a sterilisation container, then soak for a couple of minutes.
5. If you have alcohol solution in a spray model, you can spray it towards the needle head of the cartridge.
6. Once the sterilisation is complete, allow the cartridge to air dry before using it.
7. Finally, your cartridge is ready for use.

How to Use

• To ensure there is no cross-contamination, cartridges must be sterilised before treatment.
• Double-cleanse (cleanse and repeat) then wipe the skin clean with an alcohol wipe. Fully tie back your hair, away from your face. 
• Work in small areas and apply serum to each area before needling. This will help to ensure that the pen does not drag or pull on the skin. The recommended pattern to move the pen for best results is vertical, horizontal, and then diagonal in both directions. Using a light pressure and without dragging, repeat this motion over each area two times.

Please note: Comprehensive instructions are included with the device, including diagrams and helpful advice to get the best results. These instructions are also available for download via our help desk at any time, and our friendly customer service team is ready and waiting to answer any questions you may have.

DO NOT USE

• On open wounds. 
• On acne or irritated skin. 
• If irritation occurs.
• 11-pin cartridges are not suitable for hair loss

Use up to a maximum of 1mm. Refer to the Dr. Pen Needle Depth Guide. Please speak with your doctor before purchasing any Dr Pen products. The content on this site is not intended to substitute for the advice of a qualified physician, pharmacist, or other licensed health-care professional. The products may have additional information and instructions on or inside the packaging that you should carefully read and follow. Contact your health-care provider immediately if you suspect that you have a medical problem. This product may not have been evaluated by the Food and Drug Administration and is not intended to diagnose, treat, cure, or prevent any disease or health condition. For any concerns or questions, please contact your GP or dermatologist.